Test Case

Show / Hide direct link   <MAIN> 5710PA: -draft- Wireless LAN Installation and Configuration - PP-81298



Version 1
Created on 13/04/2016 16:36:21  by msesha_nw
Last modified on  14/06/2016 18:47:04  by m_komatsu_nw
Summary

 To verify WLAN driver installation and Configuration

Preconditions
Status:   New
Priority:   High
BASIC INFORMATION
Section:S/W Test Require attachment:No
Team:Network Group:Basic Function
Lessons Learned: Phase:SIT
Locations:Inhouse: AWS and Cambridge Owned By:Eiji Ogata/LENOVO
Objective:To verify installation of WLAN driver and Configurations
CRITERIA

All Tests to be performed in both AC and Battery Mode.

All Tests to be performed in both User and Admin Mode.

All supported WLAN adpters to be tested.

EUT QUANTITY
EQUIPMENT

Network PA Faciility and the following Access Points

Cisco

Apple Airport

Buffalo ac/n

Netgear ac

Linksys

Asus

Tenda

D- Link

TP-Link

Critical Attribute:WLAN driver, Card FW, OS, BIOS
CONFIGURATION

All supported WLAN adapters [ eg., Intel, Realtek (LiteON and Foxconn)

REFERENCE PROCEDURE

Please refer to attached Procedure

STATISTIC INFO
Operating System Win10-64bit Total
Test Points
Duration
Workload
# Step actions Win10-64bit
1

Silent Installation 

A
2

WLAN Radio Off

A
3

WLAN Radio On

A
4

WLAN Disable in BIOS

A
5

WLAN Enable in BIOS

A
6

WLAN Radio Off

A
7

WLAN Radio On

A
8

Uninstallation

A
9

Usual Installation

A
DETAILS
ATTENTION!! Please follow below information.
1. Please check Error and Warning message in Event Viewer before you start the test case and after you complete the test case, and report it to your team lead, then arrange to open defect, if needed.

2. Perform All Test in Battery Mode (Some of the test items need to perform in AC Mode, follow each Test Case).

3. All Test Activity should be performed with AMT Enabled as Default (applicable on vPro enabled systems).

4. Please check Usability / Cosmetic issues (correct sentence/appropriate display/etc.) and open defect, if needed.

Please refer to the attached Procedure, ignore below table !

Wireless LAN - Installation & Configuration

Test Item
Criteria
OS
Win 10
Installation with Typical/Standard Mode
1. Run the Setup.exe of the package and make sure to install typical/standard mode.
2. Restart the system.
· Confirm the Wi-Fi driver was installed successfully.
· Confirm the Wi-Fi driver can be seen in Control Panel à Add/Remove Programs
· Confirm the Bluetooth driver did not installed successfully in Device Manager and Control panel
A
Installation with Non-Typical/Standard Mode
1. Run the Setup.exe of the package and make sure to choose the non-typical/non-standard mode of installation.
2. Choose to install the Bluetooth driver.
· Confirm the Wi-Fi driver was installed successfully.
· Confirm the Wi-Fi driver can be seen in Control Panel à Add/Remove Programs
· Confirm the Bluetooth driver was installed successfully.
· Confirm the Bluetooth driver can be seen in Control Panel à Add/Remove Programs
· Make sure that there is no multiply driver and adapter entries in Add/Remove Programs and Device Manager.
A
Uninstallation of Wi-Fi Driver
1. Uninstall the Wi-Fi driver in Control Panel > Add/remove Programs
2. Restart the system.
· Confirm the Wi-Fi driver was uninstalled successfully.
· Confirm the Wi-Fi driver cannot be seen in Control Panel à Add/Remove Programs
· Confirm the Bluetooth driver is still installed successfully in Device Manager and Control panel
A
Uninstallation with Bluetooth Driver
1. Uninstall the Bluetooth driver in Control Panel > Add/remove Programs
2. Restart the system.
· Confirm the Wi-Fi driver is still installed and can be seen in Control Panel à Add/Remove Programs.
· Confirm the Bluetooth driver was uninstalled successfully in Device Manager and Control panel.
A
Uninstallation with Bluetooth and Wi-Fi Driver
1. Uninstall the Bluetooth and Wi-Fi driver in Control Panel > Add/remove Programs
2. Restart the system
· Confirm the Wi-Fi and Bluetooth driver were uninstalled successfully.
A
Silent Installation
1. Install the Wi-Fi driver using silent command as per instructions in the build letter.
2. Restart the system.
· Confirm all components are installed successfully.
Wireless Enable/Disable in BIOS
Test Item
Criteria
Win 10
Enabled Wireless LAN in Bios

1. Enter to BIOS setup by pressing F1 button

2. Under Security > I/O port Access > Wireless LAN choose Enabled

3. Press F10 to save the settings.

5. Boot to OS

Expected: The adapter should be visible in OS and configurable.

6. Install the driver and confirm that the Wireless adapter works fine.

7. Verify the functions of Wireless Radio ON and OFF.

Expected: Radio ON and OFF should function properly

· Adapter should be visible in OS
· Adapter can be configured
· Wireless Radio ON/OFF function must work
A
Disabled Wireless LAN in Bios

1. Enter to BIOS setup by pressing F1 button

3. Under Security > I/O port Access > Wireless LAN choose Disabled

4. Press F10 to save the settings.

5. Boot to OS

Expected: The adapter should NOT be visible in OS

· Adapter should not be visible in OS
· Adapter cannot be configured
A
Overwrite / Upgrade Installation
Test Item
Criteria
Win 10
Installation (Admin Mode)
- Install the driver in Admin mode using setup
- Check that the installation is successful
- Uninstall the application from 'Add/Remove programs'
- Confirm that application is removed completely.
- Install the application again.
- Check for the correct driver version and firmware version
Stand alone
Overwrite/Update Installation
[For Intel Wi-Fi adapters, update/overwrite installation is supported only from previous version to next version and cannot be performed for the same family set]
For eg. 14.x->14.x or 14.x.1 -> 14.x.2 is supported. However 15.1 -> 15.1 even if the build ID is different is not supported] - ECR98357
- Perform overwrite installation for the same driver version (INF installation)
- Check that the driver can be installed properly and no malfunction occurs
- Perform update installation from the previous version
- Check for the driver date and version.
- Verify the overwrite installation function by recovering preload and update the driver for all the applicable preloaded OS.
(LL-00950)
Overwrite/Update (Admin Mode)
Using Inbox driver
1. Perform overwrite installation for the same driver version
EXPECTED: The driver should be installed successfully and no malfunction occurs
Stand alone
Installation (user mode)
- Install the driver in user mode using setup
- Uninstall the application from 'Add/Remove programs'
Criteria : User should not be able to uninstall the driver
u
EXPECTED: Update driver software option should not be available to continue installation
Stand alone
Radio On/OFF
- Power off Wireless radio
- Confirm that the wireless utility shows radio off
- Power ON wireless radio
- Check the wireless utility picks up the nearest access point
Enable Bluetooth
- Confirm that all wireless, Bluetooth are power ON
- Leave the system for 20 minutes in idle condition.
- Verify that the system functions well without any malfunction/performance degradation.
Standalone
- Signal Status
- Check that the Wireless adapter is associated with the Access point
- Confirm that the signal strength is strong when placed near access point
Stand alone
Test Item
Criteria
Win 10
Update/Overwrite Installation with wireless profiles
1 Create multiple profiles one with encryption key and another without encryption key
2. Confirm the wireless functionality with both the profiles
3. Perform overwrite installation or driver update from older version to new version.
4. Verify that the profiles already created can be used without any problem
Stand alone
A

OTHER DETAILS

Please refer to attached procedure.

TEMS Reviewer Log:
Review Logs
Keywords:   None
Requirements :   None
Attached files :

Update History:
Modified last: 2016-06-14 18:47:04.597, by Miyuki Komatsu_nw
Modified last: 2016-06-10 19:27:52.577, by Miyuki Komatsu_nw
Modified last: 2016-06-10 19:21:09.507, by Miyuki Komatsu_nw
Modified last: 2016-06-10 19:21:01.956, by Miyuki Komatsu_nw
Modified last: 2016-04-15 16:20:30.434, by Muralidharan Seshadri_nw
Modified last: 2016-04-15 16:15:36.826, by Muralidharan Seshadri_nw